If you're lucky, the veterans in your shop will take a rookie aside and pass on their hard-won knowledge of good machining practices. Most of this information is priceless. But some of it … not so much. For example, there are a lot of myths about balancing out there that, if not refuted, can cost your operation a lot of lost time and money. In this article, Haimer USA LLC addresses these misperceptions and offers a more factual view of best practices for balancing toolholder assemblies.
Imported from the CTE archive to seed discussion on MFGAxis.
Originally published on CTE: 2017-09-28
CTE source: https://ctemag.com/news/fact-vs-fiction-truth-about-balancing-toolholder-assemblies/
Legacy path: /fact-vs-fiction-truth-about-balancing-toolholder-assemblies