MFGAxis

Newsroom

Custom machines offer solutions standard ones sometimes can’t

Every so often a job or part geometry comes along where it would be helpful to have a few extra inches in a machine's work envelope, or perhaps a little higher rpm or an additional spindle. At these and certain other times, it might be worth considering a custom machine.

Source Attribution

Source: Cutting Tool Engineering

MFGAxis keeps this page focused on the manufacturing discussion layer. Source material should stay attributed, linked when a suitable source URL is available, and limited to excerpt or summary on MFGAxis.

Every so often a job or part geometry comes along where it would be helpful to have a few extra inches in a machine's work envelope, or perhaps a little higher rpm or an additional spindle. At these and certain other times, it might be worth considering a custom machine.

Discussion

Discuss this on MFGAxis

Read replies tied to this source content and add manufacturing context without duplicating the original article, video, or release.

0 replies 0 voices
MFGAxis member April 12, 2026
Member

Every so often a job or part geometry comes along where it would be helpful to have a few extra inches in a machine's work envelope, or perhaps a little higher rpm or an additional spindle. At these and certain other times, it might be worth considering a custom machine.

No comments yet. Start the discussion on MFGAxis.

Create a post

Share a question, an idea, a photo or a video with the network.

Continue with innoNET