MFGAxis

Newsroom

High-pressure coolant breaks the vapor barrier

What would cause parts manufacturers not to want to extend tool life, increase speeds and feeds, enhance chip evacuation to avoid recutting, impart finer surface finishes and eliminate pecking when deep-hole drilling? Apparently, ignorance in the marketplace.

Source Attribution

Source: Cutting Tool Engineering

MFGAxis keeps this page focused on the manufacturing discussion layer. Source material should stay attributed, linked when a suitable source URL is available, and limited to excerpt or summary on MFGAxis.

What would cause parts manufacturers not to want to extend tool life, increase speeds and feeds, enhance chip evacuation to avoid recutting, impart finer surface finishes and eliminate pecking when deep-hole drilling? Apparently, ignorance in the marketplace.

Discussion

Discuss this on MFGAxis

Read replies tied to this source content and add manufacturing context without duplicating the original article, video, or release.

0 replies 0 voices
MFGAxis member April 12, 2026
Member

What would cause parts manufacturers not to want to extend tool life, increase speeds and feeds, enhance chip evacuation to avoid recutting, impart finer surface finishes and eliminate pecking when deep-hole drilling? Apparently, ignorance in the marketplace.

No comments yet. Start the discussion on MFGAxis.

Create a post

Share a question, an idea, a photo or a video with the network.

Continue with innoNET