MFGAxis

Newsroom

Micro-Diameter Endmills and Drills

Endmills tipped with CBN, which is the second hardest material after diamond, are offered in sizes ranging from 6mm down to 0.1mm in diameter, with various configurations, from sharp corner, radius corner, ball, standard neck length and extended neck length. TOWA offers their CBN endmills in multi-flute configurations. By maintaining the same feed per flute, and increasing the number of flutes, cutting time is reduced, while profitability is increased. The CBN series of endmills, due to the hardness of the CBN, is an excellent choice for machining harden materials in the range of 55 to over 60 Rockwell "C".

Source Attribution

Source: Cutting Tool Engineering

MFGAxis keeps this page focused on the manufacturing discussion layer. Source material should stay attributed, linked when a suitable source URL is available, and limited to excerpt or summary on MFGAxis.

Endmills tipped with CBN, which is the second hardest material after diamond, are offered in sizes ranging from 6mm down to 0.1mm in diameter, with various configurations, from sharp corner, radius corner, ball, standard neck length and extended neck length. TOWA offers their CBN endmills in multi-flute configurations. By maintaining the same feed per flute, and increasing the number of flutes, cutting time is reduced, while profitability is increased. The CBN series of endmills, due to the hardness of the CBN, is an excellent choice for machining harden materials in the range of 55 to over 60 Rockwell "C".

Discussion

Discuss this on MFGAxis

Read replies tied to this source content and add manufacturing context without duplicating the original article, video, or release.

0 replies 0 voices
MFGAxis member April 11, 2026
Member

Endmills tipped with CBN, which is the second hardest material after diamond, are offered in sizes ranging from 6mm down to 0.1mm in diameter, with various configurations, from sharp corner, radius corner, ball, standard neck length and extended neck length. TOWA offers their CBN endmills in multi-flute configurations. By maintaining the same feed per flute, and increasing the number of flutes, cutting time is reduced, while profitability is increased. The CBN series of endmills, due to the hardness of the CBN, is an excellent choice for machining harden materials in the range of 55 to over 60 Rockwell "C".

No comments yet. Start the discussion on MFGAxis.

Create a post

Share a question, an idea, a photo or a video with the network.

Continue with innoNET