MFGAxis

Newsroom

Vacuum Table

The NEMI vacuum table is designed to hold parts secure using vacuum. All you do is remove a washer with a magnet or use our auto vacuum valve and place any one of the following on top of the vacuum grid table: a pod, 5/16" round gasketing, 1/4" stand off stock and vacuum pins.

Source Attribution

Source: Cutting Tool Engineering

MFGAxis keeps this page focused on the manufacturing discussion layer. Source material should stay attributed, linked when a suitable source URL is available, and limited to excerpt or summary on MFGAxis.

The NEMI vacuum table is designed to hold parts secure using vacuum. All you do is remove a washer with a magnet or use our auto vacuum valve and place any one of the following on top of the vacuum grid table: a pod, 5/16" round gasketing, 1/4" stand off stock and vacuum pins.

Discussion

Discuss this on MFGAxis

Read replies tied to this source content and add manufacturing context without duplicating the original article, video, or release.

0 replies 0 voices
MFGAxis member April 12, 2026
Member

The NEMI vacuum table is designed to hold parts secure using vacuum. All you do is remove a washer with a magnet or use our auto vacuum valve and place any one of the following on top of the vacuum grid table: a pod, 5/16" round gasketing, 1/4" stand off stock and vacuum pins.

No comments yet. Start the discussion on MFGAxis.

Create a post

Share a question, an idea, a photo or a video with the network.

Continue with innoNET